Qualstar XLS Series Installation Manual page 106

7.4 The Power Strip and Rack Equipment
• Installed equipment rack
• Equipment to be mounted into the rack, including power cords
• Equipment rack power strip (XLS-832700 only)
• Four 6-32 × 3/8 Phillips screws for the power strip (XLS-832700 only)
• For the 6U rack:
– Twelve 10-32 × 1/2 Phillips screws (included with the rack)
– One to five cosmetic covers (included with the rack)
• For the 8U rack:
– Sixteen 10-32 × 1/2 Phillips screws (included with the rack)
– One to seven cosmetic covers (included with the rack)
7.4.1 Installing the power strip and rack equipment into the
Follow these steps:
1. Determine how you want to orient the equipment. You can access the front and
back of any installed equipment by swinging the equipment rack out to the left
and to the right. See
Figure 7-13 View from the top of the XLS showing the rack swinging out to the left and right
2. Release the top and bottom hinge latches on the appropriate side and swing the
rack out.
7-12
XLS-832700
Figure 7-13.
501601 Rev. 07-01-19