Scanning The Inventory And Locking The Doors - Qualstar XLS Series Installation Manual

14.3 Scanning the Inventory and Locking the Doors

14. Refer to
and locking the doors.
14.3 Scanning the Inventory and Locking the Doors
After scanning the fiducials, you can scan the barcode labels on any cartridges installed in
the slots to establish the library's inventory. To scan the inventory, follow these steps:
1. Access the View/Edit Hardware Configuration page as described in
on page
2. Select Scan Inventory from the Inventory section of the page.
Important:
3. Wait while the handler scans the barcode label on each cartridge, then select
Sync Inventory to update the logical library inventories with the results of the
physical library scan.
4. From the Misc section of the page, select Lock Doors. The Lock Doors page
opens, as shown in
Figure 14-6 Lock Doors page
5. Press Lock Doors. The library performs the following actions:
– It engages the solenoids controlling the electronic door locks.
– It stops flashing the yellow Attention LED.
Note:
– If any of the light curtain sensors have been violated, it rescans the cartridges
14-6
Section 14.3 on page 14-6
14-2.
Depending on the number of magazines in your library,
scanning all slots can take several hours.
Figure
If one or more I/O ports are open, the LED remains on but does not flash.
in the affected areas.
for instructions for scanning the inventory
14-6.
Section 14.2
501601 Rev. 07-01-19