Qualstar XLS Series Installation Manual page 204

13.1 Installing Cartridges in the Reserved Slots
Required tools and equipment:
• The calibration cartridge that was shipped in the XLS accessory kit. See
Figure
Figure 13-1 XLS calibration cartridge
• Four cleaning cartridges. These will be used whenever tape drive cleaning is
requested from X-Link. They are not intended for day-to-day tape drive cleaning
operations and are installed in locations that are inaccessible to the software
applications.
Procedure:
1. Open the right door.
2. Locate the five reserved cartridge slots in positions G46–G50 on the back wall of
XLS-812300, XLS-820500, and XLS-832700 libraries. The reserved cartridge
slots in XLS-8161100 libraries are located on the right side carousel and
numbered positions A46–A50. The slots are marked with a bright yellow label
that reads, "RESERVED DO NOT USE." See
13-2
13-1.
To install cartridges into the five reserved slots, follow these steps:
Make sure you have the following:
Figure 13-2 on page 13-3.
501601 Rev. 07-01-19