Qualstar XLS Series Installation Manual page 77

.
Important:
2. Using a 3/4-inch open-end wrench, turn one of the jam nuts to loosen the leveling
foot. See
Figure 5-15 Loosening a leveling foot
3. Using the same wrench, extend the leveling foot until it touches the floor. Then,
turn the nut two more complete turns. See
Figure 5-16 Extending a leveling foot
4. Repeat steps 2 and 3 to extend the three other leveling feet.
5. Check the alignment by placing a precision level on top of the LRM and MEM.
Important:
XLS Library Installation Manual
The XLS-89000 MEM also includes front and rear
carousel supports, which are located between the
leveling feet. The carousel supports are intended to keep
the carousel from sagging when it is loaded with
cartridges. Do not use these supports to level the MEM.
Figure 5-15.
Turn jam nut to
loosen leveling foot
1. Lower the foot to the floor.
2. Turn the nut 2 more turns.
Depending on the floor conditions, you may need to
adjust the leveling feet on the LRM or the MEM up or
down. Keep checking the alignment until both the LRM
and the MEM are at an even level.
5
Figure 5-16.
Installing a MEM
5-13