Lowering The Leveling Feet - Qualstar XLS Series Installation Manual

5.7 Lowering the Leveling Feet

7. Determine the direction of the bolts, as follows:
– If the MEM is to the left of the LRM (as viewed from the front):
– If the MEM is to the right of the LRM (as viewed from the front):
8. From the MEM accessory kit, obtain six 5/16 x 1/2-inch socket head screws and
washers.
9. Insert the screws through their washers and into the holes.
10. Tighten the screws with a 1/4-inch Allen wrench.
Important:
5.7 Lowering the Leveling Feet
To lower the leveling feet on the MEM, follow these steps:
1. Locate the four leveling feet on the MEM. See
Figure 5-14 Location of the four leveling feet on the MEM
5-12
• All six bolts go from the LRM to the MEM
• The three bolts in back go from the LRM to the MEM
• The three bolts in front go from the MEM to the LRM
If the holes on the MEM do not align with the holes on
the LRM, adjust the leveling feet on the MEM (see
Section 5.7).
Figure 5-14
XLS-89000
XLS-85000
501601 Rev. 07-01-19