Preparing The Lrm - Qualstar XLS Series Installation Manual

5.1 Preparing the LRM

5.1 Preparing the LRM
To prepare the LRM, follow these steps:
1. On the side of the LRM where you will install the MEM, locate the two Phillips
screws at the base of the side panel.
2. Using a #2 Phillips screwdriver, remove the two screws. See
Figure 5-1 Removing the screws from the side panel
3. Carefully slide the panel up until you can lift the hooks out of the corresponding
slots on the frame. See
Figure 5-2 Removing a side panel (XLS-832700 shown)
4. Set the screws and the side panel aside—you will install these on the MEM.
5-2
Figure 5-2.
Figure 5-1.
501601 Rev. 07-01-19