Qualstar XLS Series Installation Manual page 39

As shown in the figure, installation includes the following steps:
1. Unpack the XSL cabinets and accessories. For instructions, see
Chapter 3, "Unpacking the XLS."
2. Install the LRM. For information, see
3. Attach any MEMs. For information, see
4. Install the equipment rack in the back of the LRM (optional). See
Chapter 7, "Installing an Equipment Rack."
5. Install the tape drive assemblies. For information, see
the Tape Drive Assemblies."
6. Connect the library and the tape drives to one or more SCSI buses or Fibre
Channel networks. For information, see
7. Connect the library to power and perform the initial power on. Then, log into
X-Link from the touch screen. For information, see
Power and Logging Into X-Link."
8. Connect the library to a network or standalone computer, align the gripper to the
MEM (if installed), check the hardware configuration, and configure the physical
library and network connections. For information, see
Chapter 11, "Configuring the Physical Library."
9. If you will be operating the XLS with more than one logical library, create
additional logical libraries, as follows:
– Specify information about the logical library connections
– Specify the tape drive locations
– Specify how many cartridge slots are required
– Specify how many I/O ports are required
For information, see
10. Apply barcode labels and install the cartridges. For information, see
Chapter 13, "Loading Cartridges."
11. Scan the fiducials and cartridge inventory. For information, see
Chapter 14, "Scanning the Fiducials and Inventory."
12. Bring the logical libraries and software applications online, test the setup, then
back up the configuration. For information, see
Installation."
XLS Library Installation Manual
Chapter 4, "Installing the LRM."
Chapter 5, "Installing a MEM."
Chapter 9, "Connecting the XLS."
Chapter 12, "Setting Up Logical Libraries."
2
Preparing for Installation
Chapter 8, "Installing
Chapter 10, "Applying
Chapter 15, "Testing the
2-3