Qualstar XLS Series Installation Manual page 156

11.3 Calibrating an Expansion Pod Equipped Library
CAL Label
Figure 11-9 Pod calibration cartridge with the CAL label attached
11.3.1 The Calibration Procedure
1. Shut down the XLS Tape Library and switch the power switch to off.
2. Open the LRM door closet to the pod to be calibrated.
3. Expansion pod columns are designated A as the front column, the column closest
to the front of the library, and B as the rear column. A as front and B as back is
the same on the left and right side mounted expansion pod's.
4. Make sure the XLS tape library has firmware Version 2.01.F001 PODS
SUPPORT or higher installed.
11-10
501601 Rev. 07-01-19