Attaching The Expansion Pod To The Xls-812300 - Qualstar XLS Series Installation Manual

6.4 Attaching the Expansion Pod to the XLS-812300

2. Using a 5/32-inch Allen wrench, remove the appropriate inner hard stop from the
X-axis. See
Figure 6-11 Removing the X-axis hard stop (right side shown)
6.4 Attaching the Expansion Pod to the XLS-812300
To attach the expansion pod to the XLS-812300, follow these steps:
1. If necessary, lower the leveling feet on the XLS-812300. See
page 4-3
6-10
Figure 6-11.
for instructions.
Do not remove!
Section 4.2 on
501601 Rev. 07-01-19