Accessing Rack Equipment - Qualstar XLS Series Installation Manual

7.5 Accessing Rack Equipment

6. Swing the door open.
7. Connect power cords between any installed equipment and the power strip.
8. Connect the supplied power cord to the power connector on the power strip then
loop the cord around the post on the rear of the door as shown in
Post on the rear of the door
Figure 7-17 Power cord connected to the power strip
9. Guide the power cord through the slot in the door, then close the door making
sure the cord is not pinched.
10. Turn the thumb screw clockwise until hand tight to secure the door.
11. When appropriate, connect the power cord to the input power source and power
on the installed equipment.
You must use two separate circuits: one for the library and the other for
the equipment installed in the rack.
7.5 Accessing Rack Equipment
To access the rack equipment in the XLS-832700:
1. Determine whether you need to access the front or back of the equipment.
7-16
Power strip
CAUTION
Figure 7-17.
501601 Rev. 07-01-19