Qualstar XLS Series Installation Manual page 138

10.2 Connecting the Library to Power
To power on a library with the redundent power input module, follow these steps:
1. Locate the power switches and power connectors on the back of the library in the
lower left, as shown in
Power Cord
Restraint
Figure 10-4 Location of the power switches and power connectors
2. If the power cord restraint is attached, loosen the captive screws and remove the
restraint to access the power connectors.
3. Connect one of the power cords to power inlet 1 (on the left) and then connect the
second cord to power inlet 2 (on the right). See
Power Cord
Restraint
Figure 10-5 Attaching the power cords
4. Place the power cord restraint over the cords, as shown in
page 10-7
10-6
Figure
Captive Screws
Power Inlet 1 Power Inlet 2
and tigthen the captive screws securely.
10-4. Make sure both the switches are off.
Figure 10-5.
Figure 10-6 on
501601 Rev. 07-01-19