Qualstar XLS Series Installation Manual page 92
Tape libraries
Hide thumbs
Also See for XLS Series:
- Site planning manual (42 pages) ,
- Technical & service manual (366 pages)
Table of Contents
Advertisement
6.4 Attaching the Expansion Pod to the XLS-812300
4.
Push the expansion pod against the XLS-812300 and guide the top and bottom
alignment pins on the XLS-812300 into the corresponding holes on the expansion
pod. See
Top hole
Figure 6-14 Aligning the expansion pod with the XLS-812300
5.
Insert three 10-32 x 1-1/4 socket-head screws through the three holes on the
outside of the expansion pod. See
hole.
Figure 6-15 Location of top-most hole for securing an expansion pod to the XLS-812300
6.
Using a 5/32-inch Allen wrench, tighten the screws to secure the expansion pod to
the XLS-812300.
6-12
Figure
6-14.
Top alignment pin
Figure 6-15
for the location of the top-most
501601 Rev. 07-01-19
Advertisement
Table of Contents
