Qualstar XLS Series Installation Manual page 68

5.2 Removing the X-Axis Hard Stop
When the inner hard stops are installed, the handler is prevented from traveling too far to
the left and right. When an inner hard stop is removed, the handler can reach into an
attached MEM.
You need to remove the inner hard stop on the side where you will install the MEM.
To avoid damage to the equipment, never remove the two outer stops.
To remove an inner hard stop, follow these steps:
1. If you will install a MEM to the left of the LRM, locate the inner hard stop on the
left side of the X-axis. If you will install a MEM to the right of the LRM, locate
the inner hard stop on the right side of the X-axis.
2. Using a 5/32-inch Allen wrench, remove the appropriate inner hard stop from the
X-axis. See
Figure 5-5 Removing the X-axis hard stop (right side shown)
5-4
CAUTION
Figure 5-5.
501601 Rev. 07-01-19