Qualstar XLS Series Installation Manual page 140

10.2 Connecting the Library to Power
1. Once the power-up processes have completed, check the status of the Attention
and Fault LEDs, as follows:
– If the LEDs are off, the power-on processes completed without error and you
– If the LEDs are flashing, operator intervention is required. See
2. If the error persists, contact Qualstar Technical Support for assistance.
10.2.1 Troubleshooting Problems with XLS Power-On Processes
If the Attention or Fault LED is flashing after you have powered on the XLS, follow these
steps:
1. From the back of the library, look at each tape drive assembly and confirm that
the Drive Status LED is green, indicating that the tape drive is installed and
powered on. See
2. From the back of the library, look at each power supply and confirm that the
PWR Good LED is green and the Fault LED is off. See
page
3. Rule out common explanations for a power-on failure. See
Cause of error...
Tape drives or drive filler
assemblies not installed in all
positions
Handler unable to move
One or more doors open
One or more I/O port open
Light curtain blocked
Table 10-1 Initial troubleshooting steps for power-on error
10-8
can log in to X-Link, as described in
Section 10.2.1 for troubleshooting instructions.
Figure 10-8 on page
10-11.
Check this...
If the handler failed to move when the library was powered on,
make sure that a tape drive or drive filler assembly is correctly
installed in every tape drive position.
If the handler failed to move when you powered on the library,
make sure that nothing is blocking the handler and that the
shipment locks have been removed.
If the Attention LED is flashing slowly, make sure the doors are
securely closed.
If the Attention LED is on solid, make sure the I/O ports are
closed.
If the Attention LED is flashing rapidly, one of the light curtain
sensors may be blocked. Make sure that no cartridges are
protruding from the slots.
Section 10.3 on page
10-10.
Figure 10-9 on
Table
10-12.
10-1.
501601 Rev. 07-01-19