2.
From the Change Configuration section of the Service portlet, select Hardware
Configuration. The Hardware Configuration page opens as shown in
Figure
Figure 11-17 Hardware Configuration
3.
Under the Carousels/Pods section, select Pod2 from the appropriate drop-down
list. (Carousel/Pod installed on left or Carousel/Pod installed on right).
4.
Input the average Theta position (yaw) values as recorded above into the Theta
A and Theta B fields.
5.
Input the average X position values as recorded above into the X A and X B
fields.
XLS Library Installation Manual
11-17.
11
Configuring the Physical Library
11-21