Installing An Expansion Pod - Qualstar XLS Series Installation Manual

3. Carefully slide the panel up until you can lift the hooks out of the corresponding
slots on the frame. See
Figure 6-2 Removing the front side panel
4. Repeat steps 2 and 3 to remove the rear side panel.
5. Use a T20 Torx driver to remove the five screws that secure the attachment plate
to the rear side panel. Save these screws; you will use them to reattach the rear
panel to the XLS-812300.
XLS Library Installation Manual
Figure 6-2.
6

Installing an Expansion Pod

6-11