Qualstar XLS Series Installation Manual page 107

3. Follow the equipment manufacturers' instructions to install the equipment and
secure it to the rack at the top and bottom.
To avoid equipment damage, the total weight of the equipment
installed in the optional equipment rack should not exceed 120lbs
(54.4kg).
4. As required, install cosmetic covers over any unused positions in the rack. Using
a Phillips screwdriver, secure each plate with 10-32 screws at the top and bottom.
See
Rack equipment
Figure 7-14 Rack equipment and cosmetic covers (8U rack shown)
5. Secure the rack by inserting all four hinge latches into the holes on the frame.
To avoid equipment damage and possible injury, ensure that all four
hinge latches are completely inserted into the holes on the frame.
6. Using four 6-32 Phillips screws, attach the power strip to the interior of the
frame on either side. Orient the strip so that the main power connector is to the
bottom. See
XLS Library Installation Manual
Figure 7-14.
Cosmetic cover
Figure 7-15 on page
7
CAUTION
CAUTION
7-14.
Installing an Equipment Rack
7-13