Tools Required For Installation; Unpacking; Orientation - Qualstar 1260 User Manual

500250 K
• 220/240 volt applications - D.L.listed and CSA certified three conductor, 18
AWG, SVT vinyl jacketed cord. One end is terminated with an IEC 320, C13
style connector (CEE-22 standard sheet VI). The other end is not terminated.
The conductors are to be connected to a customer-supplied plug as follows:
Black or brown wire to AC hot (Live); white or blue wire to AC return (neutral
or common); green or green with yellow strips to chassis (ground).
The following statement is included for compliance with German safety regulations:
Die Verbindung ziir Steckdose sollte moglich kurz sein, und die Steckdose sollte frei
zuganglich bleiben.
(English translation: The connection to the power receptacle should be as short as pos-
sible, and the receptacle should be readily accessible.)
1.5 Tools Required for Installation
A #2 Phillips screwdriver is required
to
install the drive.
1.6 Unpacking
Caution!
Model 1260
tape drives weigh between 36 and 44 pounds, depending
upon the configuration. Use caution in lifting.
The tape drive is shipped in a specially designed double-walled carton with energy-
absorbing end caps. The packaging should be stored for possible future transportation
purposes.
The carton contains the following items:
• Tape Drive
• Power Cord
• User's Guide
• Interface Cable(s) (optional)
Remove the drive together with its end-caps from the carton and place it on a table.
Then remove the end-caps and the polyethylene bag.
Remove all other materials from the carton and store the end-caps and bag in the car-
ton for the possibility of future shipment.
1 .7 Orientation
The drive must be placed on a hard surface; do not place it on a typewriter pad or simi-
lar surface. It may rest on its bottom, back or side. There must be no obstructions
which would prevent air from freely flowing into the fan inlet(s) or exiting from the
ventilation slots.
Tape Drive Installation 1-3