Changing The Configuration - Qualstar XLS Series Technical & Service Manual

Section Option
Scan Magazine Fiducials
Scan I/O Port Fiducials
Scan/Calibrate Tape Drives
Scan Unscanned Fiducials
Fiducials
Calibrate Fiducials
Dump Fiducial Database
Power Off Carousel Left
Power Off Carousel Right
Carousels
Power On Carousel Left
Power On Carousel Right
Table 5-2 Options on the Service Utilities page (continued)
5.6

Changing the Configuration

This section describes how to perform the following Change Configuration procedures
from the Service portlet:
• Upload File (see
• Install File (see
• View SCSI Log Setting (see
Important:
XLS Library Technical Service Manual
Use option to...
Scan the fiducials on all storage magazines
Scan the fiducials on the I/O port magazines and scan the
inventory of each port
Scan and calibrate the tape drive locations
Based on the results of Dump Fiducial Database (see
below), scan any fiducials that were missed during the
magazine, I/O port, and tape drive scans
Based on the results of the fiducial scan operations,
calculate the positions of the fiducials for the cartridge
magazines and I/O ports
Display the database of fiducial information to establish
whether any fiducials were missed during the fiducial scans
Power off the left or right carousel controller before
replacing the carousel motor. See
page 15-23.
Power on the left or right carousel controller after replacing
the carousel motor. See
Section 5.6.1)
Section 5.6.2 on page
Section 5.6.3 on page
The View/Edit Hardware Configuration selection is
used only after a hardware part is installed or replaced.
For instructions on using this option, refer to the
appropriate FRU replacement procedure.
5
Using X-Link Service Options
Section 15.3.1 on
Section 15.3.4 on page
5-19)
5-20)
15-30.
5-75