Table of Contents
Advertisement
9.2.6 Entering the Update Password
After installing new hardware to change the configuration of an RLS, to pre-
vent possible damage to the unit, open the Front Panel/Door before applying
power. When the Front Panel/Door is open, the carriage will not move when
power is applied. The unit must be reconfigured for the new hardware, before
the carriage is allowed to move under its own power.
1.
Open the Front Panel/Door if it is not currently opened.
2.
Reconnect the power cord and turn on the RLS power.
3.
Follow the instructions in Section 5.3.1 to enter
4.
Follow the instructions in Section 9.2.7 to reconfigure the RLS.
9.2.7 Reconfiguring the Model Number
If the RLS is restricted, it may not be possible to change the RLS model number in the
Configuration\Advanced\Changer\Mechanics menu. See Section 5.1 for
details about restricted units.
1.
Press the MENU key once to display the
margin of the LCD pointing to
2.
Press the ENTER key to enter the
See the RLS Installation and Operation Manual (Qualstar document number 501500) for
complete details about the Configuration menu.
3.
Press the ENTER key to enter the
4.
Press the ENTER key to enter the
menu.
5.
Press the
press the ENTER key to enter the
501510 Rev. S
CAUTION
NOTE
Configuration
Configuration
NOTE
Configuration\Advanced
Configuration\Advanced\Changer
(DOWN) key repeatedly to move the pointer to
Configuration\Advanced\Changer\
RLS Expansions
as the password.
Update
, with the pointer in the left
Top Menu
.
menu.
Mechanics,
menu.
then
9-11
Advertisement
Table of Contents
