Rack Shelf Mounting - Mmu; Electrical Connections; Sfp / Sfp+ Slots; Ac Power Connection - Lightware UBEX-MMU-X200 User Manual

 
     
5. Installation 5. Installation
5.3. Rack Shelf Mounting - MMU
Two rack ears are supplied with the product, which are fixed on left and right side with 2x 4 pcs M4 screws.
The default position allows mounting the device as a standard rack unit installation.

WARNING! M4x8 size is the longest allowed screw for fixing the ears to the housing. Using different
(e.g. longer) ones may cause damage to the device.
WARNING!
Pay attention to the ventilation holes when designing the system. Front and rear ventilation
holes must not be covered.
INFO:
The screws for the rack frame are not supplied to the device.

INFO: The device is rack sized and 1U high.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
5.4. Electrical Connections
The following sections describe all possible electrical connections of the UBEX endpoint and MMU devices.
5.4.1. SFP / SFP+ Slots

DEFINITION:
used for both telecommunication and data communication applications. It is a popular industry format
jointly developed and supported by many network component vendors. The SFP interface supports data
rates up to 1 Gbit/s. *
DEFINITION:

supports data rates up to 10 Gbit/s. *
UBEX F-series endpoint devices and the Matrix Management Unit contain standard 1x
SFP (in the case of the MMU) and 2x SFP+ (in the case of the endpoint devices) slots
for the fiber optical connections via SFP / SFP+ modules or DAC cables. The installed
SFP / SFP+ modules can be singlemode or multimode as well.
Number of slots
Type of the slot
Maximum bandwidth per slot
Transmitted signal
For the details about the DAC cable / SFP+ module installation see the
Maximum Allowed Optical Cable Length
The maximum allowed optical cable length depends of the installed SFP / SFP+
modules. Always check the specification of the optical modules before the fiber
optical cabling.
* Source: https://en.wikipedia.org/wiki/Small_form-factor_pluggable_transceiver
5.4.2. AC Power Connection
Standard IEC Connector
UBEX F-series endpoint devices and the Matrix Management Unit contain standard IEC power
connector and works with 100 to 240 Volts AC, 50 Hz or 60 Hz power sources.
Connect the power cord to the AC input connector; the extender is immediately powered on.
The small form-factor pluggable (SFP) is a compact, hot-pluggable optical module transceiver
The enhanced small form-factor pluggable (SFP+) is an enhanced version of the SFP that
Endpoint devices
2
SFP+
10 Gbps
Audio, video, Ethernet, RS-232
37 37
MMU
1
SFP
1 Gbps
Ethernet only
SFP / SFP+ Slot Connection section.