Lightware UBEX-MMU-X200 User Manual page 104

 
     
8. Software Control - Lightware Device Controller 8. Software Control - Lightware Device Controller
HDMI Input Ports

INFO: The properties panel appears only in case of the selected source MUX settings is the HDMI in 1 or 2
for the HDMI output ports.
INFO:
The properties panel belongs to the local HDMI inputs of the receiver.
Clicking on the HDMI input 1 or 2 port icon results opens the Port properties. The most important signal
information and settings are available from the panel.
Endpoint tab of the Device properties window - Receiver - Local input port properties
Available Settings and Tools
▪ HDCP setting (Enable / Disable); #hdcp
Frame Detector - The tool displays the frame information of the original stream coming from the input
▪
port before a possible rescaling / frame rate conversion.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
SFP+ Link Panels
Clicking on the SFP+ Link 1 or 2 panel opens the properties of the SFP+ connections. The most important
signal information and the parameters of the SFP are available from the panel.

ATTENTION!
endpoint device (SFP optical module (1 GbE) instead of SFP+ module (10 GbE).
Link Aggregation Status Indicator
Icon

INFO: You can find possible causes and solution suggestions in the
of no connection or link aggregation problems.
If the icon appears that means incompatible optical transceiver module is installed to the

Description
SFP+ connection is established successfully and the link aggregation is working
successfully.
No connection is established between the SFP+ links.
104 104
#sfp
Troubleshooting chapter in the case