The Difference Between The Image Positions Of The Scaler - Lightware UBEX-MMU-X200 User Manual

 
     
6. UBEX Concept 6. UBEX Concept
6.3.6. The Difference between the Image Positions of the Scaler
The following section helps to understand how the image position settings of the scaler works. Three
different image positions are available: stretch, fit and center.

ATTENTION! The scaler settings are available on the HDMI in 1 port of the transmitter and the HDMI out 1
port of the receiver/transceiver operation modes only.
The aspect ratio of the original stream and the sink device are different in the following examples.
Stretch
The aspect ratio of the stream is distorted because it is adjusted to the aspect ratio of the sink.
Fit
The picture is adjusted to the resolution of the sink and the aspect ratio of the stream is kept, thus, the whole
picture will be displayed without cropping. The scaler fills the extra image part with black pixels.
Center
The scaler crops the center part of the stream with the resolution of the sink.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual 65 65