Lightware UBEX-MMU-X200 User Manual page 109

 
     
8. Software Control - Lightware Device Controller 8. Software Control - Lightware Device Controller
Available Settings and Tools
▪ HDCP setting (Enable / Disable); #hdcp
Frame Detector - The tool displays the frame information of the original stream coming from the input
▪
port before a possible rescaling / frame rate conversion.
HDMI Output Port

INFO: The properties panel belongs to the local HDMI output of the transceiver.
Clicking on the HDMI output 2 port icon results in opens the Port properties. The most important signal and
display information and settings are available from the panel.
Endpoint tab of the Device properties window - Transceiver - Local output port properties
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Source MUX Selector
The source multiplexer (Source MUX) makes available routing more different source signals to the HDMI
output ports. See more details about this function in the
Click on the MUX menu to expand the source MUX selector.

ATTENTION!
the MUX settings cannot be set in the audio layer.

TIPS AND TRICKS:
HDMI Out 2
▪ HDMI in 2- The signal source of the local
output port is the stream of the local
input port of the transceiver.
▪ Copy - The device is able to copy the
signal of the HDMI out 1 port. This is the
COPY function.
Available Settings and Tools
▪
HDCP mode:
– Depends on input: the level and version of HDCP-encryption depends on the source device;
– Maximum possible: the output ports set the maximum HDCP-encryption level which can accept by
the connected sink device.
– Forced HDCP 2.2 Type 1: the output ports always force HDCP 2.2 Type 1. If the sink device supports
this HDCP-encryption level, the signal will be encrypted with HDCP 2.2 Type 0/1. The signal will be
encrypted with HDCP 2.2 Type 1 when the source and the sink either support this HDCP-encryption level.
▪ Power 5V mode (Auto / Always on / Always off);
▪ Frame Detector
port before a possible rescaling / frame rate conversion.
Transceiver Mode
The audio crosspoint settings always follow the source MUX settings of the video layer and
The source of the output port can be also selected without expanding the MUX menu.
#hdcp #new
#power5v
- The tool displays the frame information of the original stream coming from the input
109 109
section. #mux #sourcemux #new