Lightware UBEX-MMU-X200 User Manual page 221

 
     
13. Assembly Guides 13. Assembly Guides
Step 3. Fasten all the six screws on the front plate using the PZ1 screwdriver.
Step 4. Insert the jog dial knob to the holder so that fixing screw hole shall be over the flat part of the holder.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Step 5. Find the screw in the side of the jog dial knob and use a 1.3 mm hexagon (Allen) wrench key to fasten it.
Step 6. Place the rubber ring carefully to the jog dial knob.
221 221