Sfp / Sfp+ Slot Connection; Installation Of Sfp / Sfp+ Modules; Installation Of Dac Cables - Lightware UBEX-MMU-X200 User Manual

 
     
5. Installation 5. Installation
5.6. SFP / SFP+ Slot Connection

INFO: The SFP / SFP+ slots support the Plug and Play connection which means UBEX devices do not need
to be powered off before inserting or removing SFP / SFP+ modules or DAC cables.
5.6.1. Installation of SFP / SFP+ Modules
Endpoint Devices
UBEX endpoint devices use SFP+ modules for the fiber optical connections.
The optical modules can be changed based on the recent application of the
extender: it can be singlemode or multimode, or BiDi modules, up to 10 GbE
signal transmission.
INFO:
It is recommended to install 2x 10 GbE SFP+ modules per endpoint in the case of HDMI 2.0
(4K@60 Hz 4:4:4) signal transmission.
Matrix Management Unit
The UBEX-MMU-X200 Matrix Management Unit has one SFP module slot for the fiber optical connection via
the network switch.

ATTENTION! The SFP port slot can handle SFP module up to 1 GbE support.
Inserting and Cabling of SFP / SFP+ Modules
Step 1. Put up on the handle bar.
Step 2. Connect the module to the to one of the SFP / SFP+ port slot.
Step 3. Connect the LC connectors to the SFP / SFP+ modules.

INFO: The SFP / SFP+ modules have a side that clips to the connector on the port of the switch, and is
designed to prevent the module from being inserted the wrong way into the port. Do NOT force module
into the port.
Removing SFP / SFP+ Modules
Step 1. Disconnect the LC connectors from the SFP / SFP+ module.
Step 2. Pull down on the handle bar.
Step 3. Gently slide out the SFP / SFP+ module from the slot.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
5.6.2. Installation of DAC Cables
Endpoint Devices
UBEX endpoints can be connected via DAC (Direct Attach Copper)
cables to the network switch. The cable type must support 10 GbE signal
transmission.

INFO: It is recommended to install 2x 10 GbE DAC cables in the case of
HDMI 2.0 (4K@60 Hz 4:4:4) signal transmission.
Matrix Management Unit
The UBEX-MMU-X200 Matrix Management Unit can be connected via DAC (Direct Attach Copper) cables to
the network switch.
ATTENTION!

Inserting the DAC Cables
Step 1. Push the plug of the DAC cable to one of the SFP / SFP+ port slot of the transmitter to stop.
Step 2. Push the other plug of the DAC cable to one of the SFP / SFP+ port slot of the receiver to stop.
Removing the DAC Cables
Pull the handle bar of the plug and gently slide out the cable from the slot.

INFO: See more details about the SFP / SFP+ interfaces in the
The SFP port slot can handle SFP module up to 1 GbE support.
47 47
SFP / SFP+ Interfaces section.