Lightware UBEX-MMU-X200 User Manual page 111

 
     
8. Software Control - Lightware Device Controller 8. Software Control - Lightware Device Controller
Analog Audio Input Port Properties Panel
DIFFERENCE:
Only the UBEX-PRO20-HDMI-F110 model has built with analog audio input port.
Clicking on the Analog in panel opens the properties of the port properties. The most important signal
information and settings are available from the panel.
Endpoint tab of the Device properties window - Transceiver - Analog audio input port properties
Settings and Tools
▪
Stream naming;
▪ Volume: sets the input volume (attenuation) between 0% (-95.62 dB) and 100% (0 dB). Clicking on the
icon results -1%, the icon results +1% in the volume setting. The default value is 100%.
 
▪ Balance: sets the balance between -100 (total left) and 100 (total right). Clicking on the
-1, the icon results +1 in the balance setting. The default value is 0 (center).

Gain: sets the gain between -12 dB and 35 dB. Clicking on the
▪
+1 dB in the gain setting. The default value is 0 dB.
ATTENTION!
The audio crosspoint settings always follow the source MUX settings of the video layer and
the MUX settings cannot be set in the audio layer.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
#analogaudio #volume #balance #gain
icon results

icon results -1 dB, the icon results
 
Analog Audio Output Port Properties Panel

DIFFERENCE: Only the UBEX-PRO20-HDMI-F110 model has built with analog audio output port.
Clicking on the Analog out panel opens the properties of the port properties. The most important signal
information and settings are available from the panel.
Endpoint tab of the Device properties window - Transceiver - Analog audio output port properties
Settings and Tools
▪
Stream naming;
▪ Volume: sets the input volume (attenuation) between 0% (-95.62 dB) and 100% (0 dB). Clicking on the
icon results -1%, the icon results +1% in the volume setting. The default value is 100%.
 
▪ Balance: sets the balance between -100 (total left) and 100 (total right). Clicking on the
-1, the icon results +1 in the balance setting. The default value is 0 (center).

Mute: enable or disable the muting of the output port.
▪

ATTENTION! The audio crosspoint settings always follow the source MUX settings of the video layer and
the MUX settings cannot be set in the audio layer.
111 111
#analogaudio #volume #balance #mute #unmute
icon results
