Installation; Mounting Options - F-Series Endpoint Devices; Mounting Bracket V2; Rack Shelf Mounting - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     

3. Installation

3. Installation
3
I nstallation
The chapter is about the installation of the device and connecting to other
appliances, presenting also the mounting options and further assembly steps:
ç Mounting Options - F-series Endpoint Devices
ç Mounting Options - R-series Endpoint Devices
ç Connections
ç Connection between F-series and R-series Endpoints
ç SFP+ Slot Connection
ç Startup of the System
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
3.1. Mounting Options - F-series Endpoint Devices
Devices can be mounted in several ways, depending on the application.
Besides using with rack shelf, a mounting bracket is available which
offers easy mounting on truss systems with standard clamps. The
bracket can be also used for building the unit into the furniture:

WARNING! Always use the supplied screws. Using different (e.g.
longer) ones may cause damage to the device.
ATTENTION!
Pay attention to the ventilation holes when designing
the system especially when the extender is built into/under
furniture. Front and rear ventilation holes must not be covered.
If a UBEX device is installed in a closed space, the designer shall
provide satisfactory ventilation to prevent excessive heat build-up
inside.
INFO:
The endpoint device is half-rack sized.
To order mounting accessories please contact sales@lightware.com.
3.1.1. Mounting Bracket V2
Mounting bracket V2 gives an opportunity to mount the device to any
furniture surface. Fasten the bracket on the side of the unit with the
provided screws and fasten it to a stand / board / truss / furniture.
Fixing the Bracket to the Device
Fasten the mounting bracket on the side of the unit with the provided
screws (4 pcs M3 screws per Mounting bracket V2).
WARNING!
M3x6 size is the longest allowed screw for fixing the
ears to the housing. Using different (e.g. longer) ones may cause
damage to the device.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2

Mounting bracket V2

1U high rack shelf
Furniture Mounting
WARNING!
Pay attention to the ventilation holes when designing
the system. Front and rear ventilation holes must not be covered.

INFO: The chipboard screws are not supplied with the mounting kit.
3.1.2. Rack Shelf Mounting
Allows rack mounting for half-rack, quarter-rack and pocket sized
units.
1U high rack shelf provides mounting holes for fastening two half-rack
or four quarter-rack sized units. Pocket sized devices can also be
fastened on the self.

WARNING! Pay attention to the ventilation holes when designing
the system. Front and rear ventilation holes must not be covered.

INFO: The screws for the rack frame are not supplied to the device.
20 20