Centralized Firmware Upgrade - Detailed Instructions - Lightware UBEX-MMU-X200 User Manual

 
     
10. Firmware Upgrade 10. Firmware Upgrade
10.5.3. Centralized Firmware Upgrade - Detailed Instructions
Preparing the Upgrade
Step 1. Open the Lightware Device Controller (LDC) software.
Step 2. Establish connection with the MMU.
Step 3. Navigate to the Settings / System Monitor / Upgrade Firmware menu.
The Layout of the Upgrade Firmware Menu
9
8
7
6 5 4
Show detailed The explanation of the two available options is the following:
1
status switcher
▪ Enabled: the last text message of the firmware upgrade status is
displayed in the Firmware Status column.
▪ Disabled: the recent status of the firmware upgrade is displayed in
percent.
2 Filters The list of the endpoint devices can be filtered, see the details in the
section (on the right side).
Factory defaults Clicking on the button results applying factory default settings on the selected
3
button endpoint devices. See the details about the applied settings in the
Default Settings
4 Reset button Clicking on the button results restarting the selected endpoint devices.
5 Identify me button Clicking on the button causes the four front panel LEDs blink in green for 10
seconds. The feature helps to identify the device itself in the rack shelf.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
1
3
section.
Update firmware
6
button
7 Endpoint device
selectors
Header
8
9 Endpoint firmware
package version
Filters
2
Applying filters help to find the required endpoint devices for upgrading
in case of a larger UBEX matrix. The function contains the following filter
categories:
▪
Device:
– UBEX-PRO20-HDMI-F100
– UBEX-PRO20-HDMI-F110
– UBEX-PRO20-HDMI-F120
– UBEX-PRO20-HDMI-R100
▪
Operation Mode:
– Transmitters
– Receivers
– Transceivers
▪ Connection Status:
– Online
– Offline
▪
Firmware Status:
– Up-to-date
Filters
– Out of date
– Update in progress
Factory
Clicking on the button results starting the firmware upgrade procedure on the
selected endpoint devices with the package version displayed in the Endpoint
Package Version.
Clicking on the squares the endpoint devices will be selected for firmware
update, identify me function, reseting or factory defaults setting. Clicking on
square next to the header results selecting all devices in the list.
The header of the endpoint list. Clicking on the

the category of the column (e.g. ID, operation mode, label, etc).
The firmware package version of the endpoint is displayed here which is built
in the MMU. This version will be applied on the endpoint devices after the
centralized firmware upgrade is completed.
200 200
icon sorts the list based on