Lightware UBEX-MMU-X200 User Manual page 106

 
     
8. Software Control - Lightware Device Controller 8. Software Control - Lightware Device Controller
Settings Tab
Clicking on the Settings menu opens the settings panel of the endpoint.
Settings tab of the Device properties window - Receiver - Network tab
Status Tab
All important information are available about the receiver, e.g. the MAC address of device, firmware versions,
system uptime, voltages, and temperatures.
Network Tab

ATTENTION! The network settings will be applied when the device is set to Extender mode. There is no
public IP address of the endpoint device when it is in Matrix mode.
IP address and DHCP settings can be set on this tab. Always press the Apply settings button to save changes.
Factory defaults settings can be recalled with a dedicated button. See the factory default settings of the
endpoint device in the Factory Default Settings
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
#status #firmwareversion
section. #network #dhcp #ipaddress #mac
Front Panel Tab
Settings tab of the Device properties window - Receiver - Front panel tab
The following settings can be set under the Front panel tab:
▪ LCD Brightness - the brightness of the LCD can be set from 1 to 10 on a scale.
▪ Lock front panel - the operation of the jog dial control knob can be locked. The settings can be unlocked
only by the LCD software or by an LW3 protocol command (see the details in the
#new
▪ Rotary direction - the rotary direction of the jog dial control knob can be set in two ways:
– Clockwise
– Counter-clockwise #rotary #jogdial
▪ Dark mode - the dark mode feature can be enabled or disabled. It keeps the LCD screen and the LEDs
unlit to hide the device during the event when the settings is enabled.
106 106
Control Lock section).
#darkmode #new