Symmetrical Analog Stereo Audio Connector; Connector; Usb Mini-B Connector; Ir Connector - Lightware UBEX-MMU-X200 User Manual

 
     
5. Installation 5. Installation
Neutrik powerCON TRUE1 Connector
UBEX R-series endpoint devices contains Neutrik powerCON TRUE1 NAC3MPX-WOT power
connector and works with 100 to 240 Volts AC, 50 Hz or 60 Hz power sources.
Connect the Neutrik powerCON to the AC input connector; the extender is immediately
powered on.
See the details about the assembly instructions for the Neutrik powerCON TRUE1 cables on
the website of the vendor:
https://www.neutrik.com/en/product/nac3mx-w-top
5.4.3. Symmetrical Analog Stereo Audio Connector
5-pole Phoenix connector is used for balanced analog audio (line in/out). Unbalanced audio signals can be
connected as well. For asymmetrical output, connect only + and ground. For asymmetrical input connect +
and ground to the source and connect – to the ground.
Compatible Plug Type
Phoenix Combicon series (3.5mm pitch), type: MC 1.5/5-ST-3.5.
®
5-pole Phoenix connector pin assignments
See more information about the most common audio cable wiring modes in
You can find more information about audio embedding and de-embedding functions in the
section.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
Pin nr. Signal
1 Left +
2 Left -
3 Ground
4 Right -
5 Right +
Audio Ports section.
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
5.4.4. RS-232 Connector
UBEX-PRO20-HDMI-F110 model and the Matrix Management Unit contains a 3-pole Phoenix connector
which is used for RS-232 serial connection.
Compatible Plug Type
Phoenix ® Combicon series (3.5mm pitch, 3-pole), type: MC 1.5/3-ST-3.5.
You can find help for the correct wiring in the
You can find more information about serial interface in the
5.4.5. USB Mini-B Connector
UBEX series devices provide standard USB 2.0 mini B-type connector for software control and
firmware upgrade purpose.

INFO: The USB control function of the MMU will be added by future firmware update.
5.4.6. IR Connector
IR detector and IR emitter can be connected to the enpoint device with TRS (Tip, Ring, and Sleeve) connectors.
They are also known as (3,5 mm or approx. 1/8") audio jack,
plug. The pin assignments are the following for the detector
Audio Interface

INFO: Ring pole of the emitter is optional. If your IR emitter has three-pole TRS plug, then the Ring and the
Sleeve are the same signal (Output - ).
You can find more information about IR interface in the
Pin nr. Signal
1 Ground
2 TX data
3 RX data
RS-232 connector pin assignments
Serial Ports section.
Serial Interface
Detector – 3-pole TRS Emitter – 2-pole TS
1 Tip Signal (active low) 1 Tip +5V
2 Ring GND 2 Ring
Signal (active low)
3 Sleeve +5V 3 Sleeve
Infrared Interface
38 38
section.
phone jack, phone plug, and mini-jack
and the emitter:
section.