Air Filter Foam Changing In R-Series Endpoints; Hidden Usb Connector For Debug Purpose - Lightware UBEX-MMU-X200 User Manual

 
     
13. Assembly Guides 13. Assembly Guides
13.3. Air Filter Foam Changing in R-series Endpoints
The R-series endpoint devices are built with an exchangeable air filter foam in front of the fans which can be
easily removed for cleaning or changing.
Removal of the Air Filter
Step 1. Disconnect the device from the power source.
WARNING!
Never remove the air filter when it is connected to the power source. The cooling fans behind
the foam are in operation when the device is on, touching the spinning parts may cause injury.
Step 2. Remove the air filter foam by fingers or using a forceps or clamp.
Parameters of the Foam
Size (in mm): 86W x 40H x 8D
Material: 25ppi polyurethane air filter foam
Installation of the Air Filter
Place the cleaned or new air filter foam in front of the cooling fans. Take care that all corners of the foam are
inside the air filter slot.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
13.4. Hidden USB Connector for Debug Purpose
UBEX endpoints are built with a standard USB 2.0 mini B-type connector which is hidden under the jog dial
control knob.

ATTENTION!
requests it.
Follow the steps to reach the hidden USB connector:
Step 1. Remove the rubber ring from the jog dial knob.
Step 2. Find the screw in the side of the jog dial knob and use a hexagon (Allen) key wrench size 1.3mm to loosen it.
Step 3. Pull down the jog dial knob from the holder.
Step 4. The USB mini connector is available now.
The USB connector is for debug purpose. Please use it only in case of the Lightware Support
The location of the hidden USB mini connector
223 223