Video Wall Application - Lightware UBEX-MMU-X200 User Manual

 
     
1. Introduction 1. Introduction
1.7.3. Video Wall Application
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Application diagram of Matrix mode - Video wall application
Description
The UBEX matrix contains two transmitters and four receivers
(UBEX-PRO20-HDMI-F100 endpoint models).
The matrix is supervised by the UBEX Matrix Management Unit (MMU)
which is controlled by a PC. All endpoint devices and the MMU are
connected to a 96-port 10G Layer 3 network switch.
The receivers are connected to four wall-mounted displays in a 2x2
video wall application. The source streams are from four different
source devices (PC, Blu-ray player, 4K media player, and laptop) and
transmitted by the two UBEX transmitters.
The video wall may have more different layouts and a layout may be
divided into more zones. See more details about video wall feature in
the Video Wall section.
The UBEX matrix is controlled by a RAP-B511-EU-K room automation
panel which can send LW3 protocol commands to the MMU over
Ethernet. The control buttons of the RAP panel can be programmed for
the best available supervising of the video wall, for example changing
the layout of the wall, or crosspoint changing for each zones, etc.

INFO: RAP-B511 series devices can be ordered separately for the
UBEX matrix. For the details please contact sales@lightware.com.
18 18