Lightware UBEX-MMU-X200 User Manual page 88

 
     
8. Software Control - Lightware Device Controller 8. Software Control - Lightware Device Controller
Switching Operations
Take Mode
If the Autotake button is grey colored the Take mode is active. In Take mode any crosspoint
change – connecting/disconnecting ports to/from the previously selected port – is executed
only after pressing the Take button. Following steps describe the process of the switching:
Input switching in Take mode
Step 1. Press the desired Input switch or Output switch button to select the switching mode.
Step 2. Select the desired port; it will be highlighted with orange color and displayed also in the Selected port
section on the left.
Step 3. Connected ports are highlighted with white color and displayed also in the Connected ports section on
the left.
Step 4. Create the desired crosspoint settings by selecting/deselecting the ports; they will start to blink.
Step 5. Press the Take button to execute changes or Cancel to discard.

INFO: Take mode remains active until it is switched off. Selecting another view mode or menu item does
not effect the Take/Autotake mode state.
#switch #crosspoint
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Autotake Mode
If the Autotake button is yellow colored, the Autotake mode is active. In this mode, any
crosspoint change – connecting/disconnecting ports to/from the previously selected
port – is executed immediately after pressing the port button. Following steps describe the process of the
TAKE
switching:
Step 1. Press the desired Input switch or Output switch button to select switching mode.
Step 2. Select the desired port; it will be highlighted with orange color and displayed also in the Selected port
section on the left.
Step 3. Connected ports are highlighted with white color and displayed also in the Connected ports section on
the left.
Step 4. Create the desired crosspoint settings by selecting/deselecting the ports; the changes are executed
immediately.

INFO: Autotake mode remains active until it is switched off. Selecting another view mode or menu item
does not effect the Take/Autotake mode state.
Output switching in Autotake mode
88 88
AUTOTAKE