Introduction; Menu Navigation; Operation Mode Visualization; Parameter Selection - Lightware UBEX-MMU-X200 User Manual

 
     
4. Front Panel LCD Menu Operation - Endpoints 4. Front Panel LCD Menu Operation - Endpoints
4.2. Introduction
4.2.1. Menu Navigation
The front panel has a color LCD that shows the most important
settings and parameters structured in a menu. The jog dial
control knob can be used to navigate between the menu items
or change the value of a parameter. The knob can be turned and
clicked to enter a menu or edit/set a parameter.
TIPS AND TRICKS:
The faster you rotate the jog dial, the
faster the parameter list is scrolled.
4.2.2. Operation Mode Visualization
The current operation mode of the UBEX endpoint is displayed with two methods on the LCD screen for the
easier recognition:
▪ The color of the header is blue for the transmitter, white for the receiver, and black with a white stripe for
the transceiver;
▪ There is a TX, RX, or TRX label in the main menu of the menu structure.
Home screen of the transmitter
4.2.3. Parameter Selection
The blue colored line means the selected menu/parameter, the
means the current setting.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4

Menu navigation

& change parameter
Turn
Home screen of the receiver Home screen of the transceiver
green one
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
4.3. Home Screen
The current status of the input and output ports of the device is summarized on the Home screen. The
device label (which can be modified by the user) and the operation mode is displayed in the top row.
Menu selection
& set parameter
Press
Home screen of the transmitter
The device label can be modified by the following methods:
▪ Using the Lightware Device Controller (LDC) software - see the details in the
TRX operation modes) and in the
Using LW3 protocol command - see the details in the
▪
The icons display information about the port and the incoming/transmitted signals.
Icon




Take any action (turning or pressing) with the jog dial control knob to enter the Main menu.
Home screen of the receiver
Device Information (RX and TRX operation modes) sections.
Set the Device Label
Icon is blue (inactive) Icon is white (active)
Sink is not connected Sink is connected
Signal is not present Signal is present
Signal is not encrypted with HDCP Signal is encrypted with HDCP
No audio signal in the video stream Audio is embedded in the video stream
29 29
#new
Home screen of the transceiver
Device Information (for TX and
section.