R-Series Endpoints - Receiver Operation Mode - Lightware UBEX-MMU-X200 User Manual

 
     
5. Installation 5. Installation
5.5.5. R-series Endpoints - Receiver Operation Mode
2xMM-2xDUO and 2xSM-2xDUO
2xMM-QUAD and 2xSM-QUAD
2xSM-BiDi-DUO
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Local HDMI in
HDMI out
Ethernet
Power
OPT DUO
OPT QUAD
OPT DUO
OPT QUAD
OPT BiDi DUO

WARNING!
network loop.

INFO: The HDMI input ports can be used as local input ports only when the device is configured as receiver.
* You can find more information about the cabling between the switch the R-series endpoint devices in the
Connection between the Switch and R-series Endpoints
Connect the local source devices (e.g. PC, Blu-ray player) using the HDMI
input 1 and 2 ports by HDMI cables.
Connect the sink devices (e.g. monitor, projector) to the HDMI output 1 and
2 ports by HDMI cables.
Optionally connect the receiver to a LAN in order to control the device.
Connect the power adaptor to the AC input on the receiver first, then to the
AC power socket.
Connect the device and the L3 network switch by 2 pcs multimode Neutrik
opticalCON DUO or 4 pcs multimode LC fiber optical cables. *
Connect the device and the L3 network switch by a multimode Neutrik
opticalCON QUAD fiber optical cable. *
Connect the device and the L3 network switch by 2 pcs singlemode Neutrik
opticalCON DUO or 4 pcs singlemode LC fiber optical cables. *
Connect the device and the L3 network switch by a singlemode Neutrik
opticalCON QUAD fiber optical cable. *
Connect the device and the L3 network switch by a singlemode Neutrik
opticalCON DUO BiDi or 2 pcs singlemode LC fiber optical cables. * The
connector does not support the Neutrik opticalCON cross cable. Please use
standard cable only.
User Ethernet is also transmitted over the fiber optical interface so be sure not to create
section.
44 44
#new