Lightware UBEX-MMU-X200 User Manual page 112

 
     
8. Software Control - Lightware Device Controller 8. Software Control - Lightware Device Controller
Settings Tab
Clicking on the Settings menu opens the settings panel of the endpoint.
Settings tab of the Device properties window - Transceiver - Status tab
Status Tab
All important information are available about the transceiver, e.g. the MAC address of device, firmware
versions, system uptime, voltages, and temperatures.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
#status #firmwareversion
Network Tab
Settings tab of the Device properties window - Transceiver - Network tab

ATTENTION! The network settings will be applied when the device is set to Extender mode. There is no
public IP address of the endpoint device when it is in Matrix mode.
IP address and DHCP settings can be set on this tab. Always press the Apply settings button to save changes.
Factory defaults settings can be recalled with a dedicated button. See the factory default settings of the
endpoint device in the Factory Default Settings section.
112 112
#network #dhcp #ipaddress #mac