Receiver Mode - F110 Model - Lightware UBEX-MMU-X200 User Manual

 
     
6. UBEX Concept 6. UBEX Concept
6.5.5. Receiver Mode - F110 Model
Port Diagram
The port diagram is valid for the following UBEX endpoint model:
▪ UBEX-PRO20-HDMI-F110
Port diagram of the F110 receiver
Description
The device is built with a 4x3 digital audio crosspoint which has four inputs: three digital audio streams are
received from the SFP+ links, the fourth input is the stream of the analog audio in port. The audio streams
can be selected to the HDMI out 1 and 2, and the analog audio out ports.
The stream of the analog audio in port is transmitted over the SFP+ links.
The HDMI input ports do not accept signals when the device is configured as receiver.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Source Multiplexer (MUX)

INFO: The source MUX function can be set on the video side only in the Lightware Device Controller (LDC)
software and using LW3 protocol commands as well.
The source multiplexer (Source MUX) makes available routing more different source signals to the HDMI
output ports. The type of sources is different by the two outputs.
HDMI out 1
▪ Able to accept audio signal via the SFP+ links from the remote endpoint device;
▪ Able to accept audio signal via the local HDMI in 1 port.
HDMI out 2
▪ Able to accept audio signal via the SFP+ links from the remote endpoint device;
▪ Able to accept audio signal resolution via the local HDMI in 2 port;
▪ Able to copy the signal of the HDMI out 1 port. This is the COPY function.
HDMI Input Modes
The HDMI input ports of the receiver operate as local HDMI inputs.
Signal Support of the Analog Audio Output
The UBEX-PRO20-HDMI-F110 endpoint model converts the uncompressed stereo audio stream to analog audio.
The analog audio output port supports PCM audio format up to 48 kHz.

ATTENTION!
automatically. The current status of the port can be queried by an LW3 protocol command, see the details
in the Query the Status of the Analog Audio Output
If unsupported audio signal is selected to the analog audio output, the port will be muted
section.
73 73