F-Series Endpoints - Transceiver Operation Mode - Lightware UBEX-MMU-X200 User Manual

 
     
5. Installation 5. Installation
5.5.3. F-series Endpoints - Transceiver Operation Mode
Connections for the F110 model in transceiver operation mode
Changing the Operation Mode
The operation mode of the UBEX endpoint device can be changed using the following methods.
Before connecting the device to the network and the MMU:
▪ via front panel LCD menu;
After connecting the device to the network and the MMU:
▪ via Lightware Device Controller (LDC) software - see the details in the
via LW3 protocol command - see the details in the
▪
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Device Map section;
Set the Operation Mode section.
Connect singlemode or multimode (depends on the installed SFP+ modules)
OPT
fiber optical cables or DAC cables between the transceiver and the Layer 3 (L3)
DAC
network switch. The Matrix Mode is detected and applied automatically in the
device once the MMU claims the endpoint.
HDMI in Connect the source device (e.g. PC) using the HDMI input 2 port by an HDMI
cable.
HDMI out Connect a sink device (e.g. monitor) to the HDMI output 1 port by an HDMI
cable.
Connect a local sink device (e.g. 4K TV) to the HDMI output 2 port by an HDMI
Local HDMI out
cable.
Optionally connect the transceiver to a LAN in order to control the device.
Ethernet
Power
Connect the power adaptor to the AC input on the transceiver first, then to the
AC power socket.
Audio in
Connect an audio source (e.g. media player) to the audio input connector.
Audio out Connect an audio sink device (e.g. audio amplifier) to the audio output connector.
IR in Connect an Infrared detector unit to the IR IN connector for receiving Infrared
input signal.
IR out
Connect an Infrared emitter unit to the IR OUT connector for controlling third-
party devices over Infrared signal.
RS-232 Optionally for RS-232 extension: connect the controlled unit (e.g. 4K TV) to the
RS-232 port of the device with a serial cable.

WARNING! User Ethernet is also transmitted over the SFP+ interface so be sure not to create network
loop.
INFO:
The HDMI input 1 port cannot accept AV signal when the device is configured as transceiver.
42 42