Sfp+ Bidi To Neutrik Opticalcon Duo Bidi - Lightware UBEX-MMU-X200 User Manual

 
     
5. Installation 5. Installation

ATTENTION! Always be sure that the fiber optical mode of the entire fiber optical equipment (SFP+
modules, LC patch cables, Neutrik connectors, and cables) and R100 endpoint device are the same.
Connecting to the 2xMM-QUAD model requires multimode equipment, connecting to the 2xSM-QUAD model
requires singlemode equipment.
Required fiber optical equipment for connecting the network switch and an R100 QUAD endpoint device

INFO: This method does not work in case of using DAC cables in the network switch.
5.8.3. SFP+ BiDi to Neutrik opticalCON DUO BiDi
This method is working with the following endpoint model:
▪ UBEX-PRO20-HDMI-R100 2xSM-BiDi-DUO
Connecting Steps
Step 1. Insert 2 pcs 10GbE singlemode SFP+ BiDi transceiver modules to the SFP+ slots of the network
switch.
Step 2. You need a singlemode/multimode Neutrik opticalCON DUO BiDi connector and 2 pcs singlemode/
multimode fiber optical patch cables with LC simplex connectors. Connect the SFP+ modules and
the back of the Neutrik opticalCON DUO connector by the patch cables (a standard LC duplex
connector can be found on the back of the Neutrik opticalCON DUO connector).

TIPS AND TRICKS: The extra Neutrik
connector can be assembled to a blank
1U high rack shelf which can make easier
the mounting of the connectors and the
cabling.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Step 3. Establish connection between the additional Neutrik opticalCON DUO connector and the R100
endpoint device by a singlemode/multimode Neutrik opticalCON DUO BiDi cable. The following figure
shows the correct cabling layout of optical connectors on the R100 endpoint device:
Layout of the 2xSM-BiDi-DUO model (rear view)
Channel
A
B
ATTENTION!

Please use standard cables only.
Step 4.

ATTENTION!
modules, LC patch cables, Neutrik connectors, and cables) and R100 endpoint device are the same.
Connecting to the 2xSM-BiDi-DUO model requires singlemode equipment.
Required fiber optical equipment for connecting the network switch and an R100 2xSM-BiDi-DUO endpoint

INFO: This method does not work in case of using DAC cables in the network switch.
SFP+ modules behind th Neutrik opticalCON DUO connector
Type of the SFP+ module
Finisar FTLX2072D327
Finisar FTLX2072D333
The 2xSM-BiDi-DUO model does not support the Neutrik opticalCON DUO cross cables.
Always be sure that the fiber optical mode of the entire fiber optical equipment (SFP+
device
50 50
Layout of the extra connector
(rear view)
Wavelength
1271 nm
1331 nm