Front And Rear View - R-Series Endpoint Devices; Front View - Lightware UBEX-MMU-X200 User Manual

 
     
2. Product Overview 2. Product Overview
2.2. Front and Rear View - R-series Endpoint Devices
2.2.1. Front View
All Models
1
1 Mounting ears Durable mounting ears on both sides of the device for the easy mounting in the
case of rental or staging application. The ears serve more purposes, see the
details in the
Status LEDs The LEDs give immediate feedback about the current status of the endpoint
2
device. See the details about the operation of the LEDs in the
(on the right side).
3 LCD screen LCD screen showing the most important settings and parameters in the front panel
menu. The available settings and information depends on the current application
mode. See the details in the
4 Jog dial Easy setting and menu navigation by the jog dial control. Keep dialing and click
control knob while getting feedback on the LCD.
The operation of the jog dial control knob can be disabled by the control lock
feature. The function can be enabled by the following methods:
▪ Lightware Device Controller (LDC) software / Built-in website - see the details in
the Health Status Tab
LW3 protocol command - see the details in the
▪
5 Reset button Reboots the device (the same as disconnecting from the power source and
reconnecting again).
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
2 3 4
Mounting Options - R-series Endpoint Devices section.
Status LEDs
Front Panel LCD Menu Operation - Endpoints
section;
Control Lock
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Status LEDs
5 LIVE
blinking The device is powered and ready to use.
1
STATUS
blinking Measured temperature or voltage value is out of the limits.
LINK OK
blinking
section
MMU AVAILABLE
chapter.
blinking Matrix mode is active; no communication between the endpoint and the MMU.
#new
Dark Mode
Rental application requires this function, which keeps the LCD screen and the LEDs unlit to hide the device
during the event. The function can be enabled by the following methods:
section.
Front panel LCD menu - see the details in the
▪
▪ Lightware Device Controller (LDC) software / Built-in website - see the details in the
section;
▪ LW3 protocol command - see the details in the
off The device is not powered or out of operation.
on All measured temperature and voltage values are within the limits.
off The device is not powered or out of operation.
The connection is established on the fiber optical links and the Link Aggregation is
on
working.
The connection is established on the fiber optical links and LACP detection period is
active.
off No connection is established on one of the fiber optical links.
Matrix mode is active; the communication is live between the endpoint and the Matrix
on
Management Unit (MMU).
off Extender mode is active; no communication between the endpoint and the MMU.
Front Panel
Dark Mode Setting
22 22
Transmitter / Receiver / Transceiver
Transmitter / Receiver / Transceiver
Transmitter / Receiver / Transceiver
Transmitter / Receiver / Transceiver
#new
section;
Health Status Tab
section.