Introduction; Menu Navigation; Parameter Selection; System Settings Menu - Lightware UBEX-MMU-X200 User Manual

 
     
3. Front Panel LCD Menu Operation - MMU 3. Front Panel LCD Menu Operation - MMU
3.1. Introduction
3.1.1. Menu Navigation
The front panel has a color LCD that shows the most important
settings and parameters structured in a menu. The jog dial
control knob can be used to navigate between the menu items
or change the value of a parameter. The knob can be turned and
clicked to enter a menu or edit/set a parameter.
3.1.2. Parameter Selection
The blue colored line means the selected menu/parameter, the
means the current setting.
TIPS AND TRICKS:
The faster you rotate the jog dial, the faster the
parameter list is scrolled.
3.2. System Settings Menu
System related settings are available in the menu - network and time/date
settings.
3.2.1. Network
The parameters of the network connection can be set in this submenu.
The first three lines (IP, Subnet, and Gateway parameters) show the current
settings. If the DHCP option is disabled, three more parameters are listed
which can be set for a static IP address:
Static IP,
▪
▪ Static Subnet,
▪ Static Gateway.

ATTENTION! If you change the network settings, always press the Save
option under Network menu (not only in the submenu of the parameter)
to apply the new settings. #network #dhcp #ipaddress
3.2.2. Time and Date
The internal clock and date that is used for logging events can be set in this
submenu. #time #date
Time format: HH:MM:SS
Date format: YYYY-MM-DD
TIPS AND TRICKS:
The time and date can be set easily in the built-
in web or in the Lightware Device Controller software manually or by
synchronizing with the local computer. See the details in the
section.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual

Menu navigation

Menu selection
& change parameter & set parameter
Press
Turn
green one
System Tab
3.2.3. Display Brightness
The brightness of the LCD can be set from 1 to 10 on a scale. Use the jog
dial control knob to set the brightness lower or higher.
3.2.4. Restore Factory Defaults
Selecting this submenu results the factory default settings being reloaded
after a reboot. See the entire list of restored settings for the Matrix
Management Unit in the UBEX-MMU-X200 section. #factory
26 26