Matrix Management Unit (Mmu) - Lightware UBEX-MMU-X200 User Manual

 
     
5. Installation 5. Installation
5.5.7. Matrix Management Unit (MMU)
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Connections for the UBEX-MMU-X200 Matrix Management Unit
Two possibilities are available to connect the MMU to
OPT / DAC
Ethernet the Layer 3 (L3) network switch:
▪ via Ethernet: use the CATx port of the UBEX
Network for the Ethernet connection between
the devices, OR
▪ via SFP port:
– use a singlemode or multimode (depends
on the installed SFP (not SFP+) modules)
fiber optical cables or DAC cables between
the MMU and the Layer 3 (L3) network
switch.
– use CATx cable between the MMU and the
Layer 3 (L3) network switch when RJ45
SFP (not SFP+) module is installed to the
slot.
Ethernet Connect a controller device (e.g. PC, laptop) to the
MMU with a CATx cable for the connection to the LAN
network.
RS-232 Optionally connect third-party controller devices (e.g.
system controller, touch controller) with a serial cable
via the RS-232 1 and 2 connectors.
Power
Connect the power adaptor to the AC input on the MMU
first, then to the AC power socket.
INFO:
The USB control function will be added by future firmware
update.
46 46