Front Plate Exchange For F-Series Endpoint Devices; Tool Requirements; The Steps Of The Front Plate Exchange - Lightware UBEX-MMU-X200 User Manual

 
     
13. Assembly Guides 13. Assembly Guides
13.1. Front Plate Exchange for F-series Endpoint Devices
The section is about the assembling of the UBEX F-series endpoint devices which contains detailed step-by-
step guides and the tool requirements.
Affected Models
The front plate can be changed on the following endpoint models:
▪ UBEX-PRO20-HDMI-F100
▪ UBEX-PRO20-HDMI-F110
13.1.1. Tool Requirements
Plastic spudger tool 1.3 mm hex wrench (Allen) key
13.1.2. The Steps of the Front Plate Exchange
Removal of the Front Plate
Step 1. Remove the rubber ring carefully from the jog dial knob using the plastic spudger tool.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Step 2. Find the screw in the side of the jog dial knob and use a 1.3 mm hexagon (Allen) wrench key to loosen it.
Step 3. Pull down the jog dial knob from the holder.
PZ1 screwdriver
Step 4. Remove all the six screws from the front plate using the PZ1 screwdriver.
219 219