Transmitter Operation Mode - Lightware UBEX-MMU-X200 User Manual

 
     
8. Software Control - Lightware Device Controller 8. Software Control - Lightware Device Controller
8.11.1. Transmitter Operation Mode
HDMI Input Ports
Clicking on the HDMI input 1 or 2 port icon results opens the Port properties. The most important signal
information and settings are available from the panel.
Endpoint tab of the Device properties window - Transmitter - Input port properties
Available Settings and Tools
▪ HDCP setting (Enable / Disable); #hdcp
▪ Frame Detector - The tool displays the frame information of the original stream coming from the input
port before a possible rescaling / frame rate conversion.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
HDMI Output Ports

INFO: The properties panel belongs to the local HDMI outputs of the transmitter.
Clicking on the HDMI output 1 or 2 port icon results in opens the Port properties. The most important signal
and display information and settings are available from the panel.
Endpoint tab of the Device properties window - Transmitter - Local output port properties
Available Settings and Tools
▪
HDCP mode:
– Depends on input: the level and version of HDCP-encryption depends on the source device;
– Maximum possible: the output ports set the maximum HDCP-encryption level which can accept by
the connected sink device.
– Forced HDCP 2.2 Type 1: the output ports always force HDCP 2.2 Type 1. If the sink device supports
this HDCP-encryption level, the signal will be encrypted with HDCP 2.2 Type 0/1. The signal will be
encrypted with HDCP 2.2 Type 1 when the source and the sink either support this HDCP-encryption level.
▪ Power 5V mode (Auto / Always on / Always off);
▪ Frame Detector
port before a possible rescaling / frame rate conversion.
#hdcp #new
#power5v
- The tool displays the frame information of the original stream coming from the input
97 97