Keeping The Configuration Settings - Lightware UBEX-MMU-X200 User Manual

 
     
10. Firmware Upgrade 10. Firmware Upgrade
10.7. Keeping the Configuration Settings
By default, device configuration settings are restored when firmware upgrade is finished. If factory reset has
been chosen in the parameters window, all device settings will be erased. In the case of factory reset you
can save the settings of the device in the Lightware Device Controller software and restore it later. See the
details in the System Tab section.
The following flow chart demonstrates how this function works in the background.
Start of the Upgrade
1
The device downloads
2 Backup
The current configuration of the device is being saved into a configuration backup file on your
computer. You can find a detailed list about the saved settings in the
3 Upgrade
The CPU firmware is changed to the newer ones in the package.
4 Factory reset
Before the upgrade all configuration settings are restored to the factory default values.
Conversion / Restore
5
Before the restore procedure the firmware package checks the backup data and if it is needed,
a conversion is applied to avoid incompatibility problems between the firmware versions.
After the conversion all configuration settings are restored to the device.
When the factory default option is enabled in the Parameters window, the conversion / restore procedure
will not be performed!
End
6
Once the firmware upgrade procedure is finished, the device reboots and is ready to use.
The details about the procedure: when firmware upgrade starts, the first step is making a backup of the
settings of the device. The firmware package checks the backup data and if it is needed, a conversion is
applied to avoid incompatibility problems between the firmware versions. If you want to keep configuration
settings, enable the Restore device configuration option in the Parameters menu, else you can set the Factory
default option enabled.
Applied F-series endpoint firmware package: v1.5.4 | Applied R-series endpoint firmware package: v1.5.4 | Applied MMU firmware package: v1.3.3 | LDC software: v2.4.2b4
series – Matrix Application Mode – User's Manual series – Matrix Application Mode – User's Manual
Content of Backup File section.
207 207