Mitsubishi Electric MELDAS 60 Series Parameter Manual page 176

# Items
ext23 Absolute
(bit7) coordinate
display
[Special display
unit compatible]
1288 ext24 MDI program
(PR) (bit0) clear
1289 ext25
(PR)
1290 ext26
(PR)
1291 ext27
(PR)
1292 ext28
(PR)
1293 ext29
(PR)
1294 ext30
(PR)
1295 ext31
(PR)
1296 ext32
(PR)
1297 ext33
(PR)
1298 ext34
(PR)
5. Base Specifications Parameters
Details
(M system)
0: Display the actual position including tool
radius compensation.
1: Display the machining position in terms of a
program command excluding tool radius
compensation.
(L system)
0: Display the actual position including nose R
compensation.
1: Display the machining position in terms of a
program command excluding nose R
compensation.
With the L system, the effect onto the nose R
compensation's absolute coordinate counter is also
affected by the L system coordinate changeover
parameter (#1227 aux11/bit 3 absolute coordinate
changeover (nose R)). In actual use, if this
parameter is set to 1, or if #1227 aux 11/bit 3 is set
to 1, the position in the program commands will be
displayed with the absolute coordinate counter.
Select whether to initialize the MDI buffer when MDI
operation ends, the power is turned ON again, reset
is input, or emergency stop is canceled.
0: Do not clear programs registered with MDI.
1: Clear programs registered with MDI, and
save only % programs.
Not used.
Not used.
Not used.
Not used.
Not used.
Not used.
Not used.
Not used.
Not used.
Not used.
II - 80
Setting range (unit)
0/1
0/1