Mitsubishi Electric MELDAS 60 Series Parameter Manual page 66

Error No. Error message
E25 DATA MEMORY
ERR
E26 NO
CHARACTERS
E35 COMPARE
ERROR
E40 OP MODE ERROR
E50 FILE ERR
E51 FILE OPEN ERR
FILE CLOSE ERR
E52 FILE SEEK ERR
E53 FILE READ ERR
FILE DELETE
E54 ERR
FILE INSERT ERR
E55
E56
2. Operation Messages on Setting And Display Unit
2.1 Operation Errors
×
• When inputting the tool offset data onto tape‚ an offset type
exceeding the specifications range was designated‚ and that
block could not be input. If the INPUT key is pressed again in the
input screen‚ the input will continue from the next block.
∆
• The designated character string was not found from the block
displayed on the screen to the end of the program when
searching with data search in the edit screen. Press the INPUT
key again' and the search will start at the head of the program.
×
• An inconsistency was found in the paper tape and memory data
during comparison.
×
• Continuous or step graphic check was not possible because the
operation mode was illegal.
×
• If one of these errors occurs‚ the editing or input/output
operations cannot be continued. Contact the Service Center.
As for E50‚ a classification No. will display at the end of the
message. Inform the service center of this No. as well.
E55 is also displayed when deleting the system configuration
data "ASSEMBLY.INF" of NC memory was attempted on host
screen. The system configuration data cannot be deleted.
Details
I - 52