Mitsubishi Electric MELDAS 60 Series Parameter Manual page 342

No. Items
3243 SP043 TRNG
(PR)
3244 SP044 TRANS
(PR)
3245 SP045 CSNT
3246 SP046 CSN2
(PR)
3247 SP047 SDTR
(PR)
3247 SP047 SDTR
(PR)
3248 SP048 SUT
(PR)
3249 SP049 TLM2
3250 SP050 TLM3
3251 SP051 TLM4
3252 SP052 TLM5
3253 SP053 TLM6
3254 SP054 TLM7
8. Spindle Parameters
8.3 MDS-B-SP/SPH, MDS-C1-SP/SPH
Synchro- This parameter is used to set the synchronous
nous tapping or spindle synchronous detector range.
tapping, Set "0" for this parameter.
spindle
synchro-
nous
detector
range
NC Set a frequency of data communication with
communi- NC.
cation
frequency
Dual Set the cycle to add the increment values in the
cushion dual cushion process.
timer When this setting value is increased, the dual
cushion will increase, and the changes in the
speed during acceleration/deceleration will
become gradual.
Speed For an acceleration/deceleration time constant
command defined in SP019 (CSN1) , this parameter is
dual used to provide smooth movement only at the
cushion start of acceleration/deceleration.
As the value of this parameter is smaller, it
moves smoother but the
acceleration/deceleration time becomes longer.
To make this parameter invalid, set "0".
Speed Set the reset hysteresis width for a speed
detection detection set value defined in SP020 (SDTS).
reset value
Speed Set the reset hysteresis width for a speed
detection detection set value defined in SP020 (SDTS).
reset value
Speed Set the speed deviation rate with respect to the
reach commanded speed for output of the speed
range reach signal.
Torque Set the torque limit rate for the torque limit
limit 2 signal 010.
Torque Set the torque limit rate for the torque limit
limit 3 signal 011.
Torque Set the torque limit rate for the torque limit
limit 4 signal 100.
Torque Set the torque limit rate for the torque limit
limit 5 signal 101.
Torque Set the torque limit rate for the torque limit
limit 6 signal 110.
Torque Set the torque limit rate for the torque limit
limit 7 signal 111.
Details
II - 246
Setting Standard
range setting
0 to 7 0
0 to 32767 Standard:
0
Special:
1028
0 to 1000 0
(ms)
0 to 1000 0
0 to 1000 30
(r/min)
0 to 1000 30
(r/min)
0 to 100 15
(%)
1 to 120 20
(%)
1 to 120 30
(%)
1 to 120 40
(%)
1 to 120 50
(%)
1 to 120 60
(%)
1 to 120 70
(%)