Mitsubishi Electric MELDAS 60 Series Parameter Manual page 204

# Items
2076 index_x Index table
indexing
axis
2077 G0inps G0
in-position
width
2078 G1inps G1
in-position
width
2079 chcomp Chopping
compensa-
tion
coefficient
2080 chwid Bottom
dead center
position
width
2081 chclsp Maximum
chopping
speed
2082 a_rstax Restart
position
return order
6. Axis Specifications Parameters
6.4 Axis Specifications Parameters 2
Specify the index table indexing axis.
0: Normal axis
1: Index table indexing axis
Note: This parameter is valid only for the NC axis. The
parameter is invalid if specified for the PLC axis.
When an in-position check is performed for G0, this
parameter is valid.
(Comparison of SV024 and this parameter, the
parameter that the in-position width is wider is applied.)
When 0 is set, this parameter is invalid.
(Applicable only to SV024)
When an in-position check is performed for G1, this
parameter is valid.
(Comparison of SV024 and this parameter, the
parameter that the in-position width is wider is applied.)
When 0 is set, this parameter is invalid.
(Applicable only to SV024)
Set the coefficient applied on the compensation amount
for the insufficient amount caused by servo delay
during chopping.
Set the tolerance between the commanded stroke and
actual stroke.
During chopping, if the (command width - maximum
stroke of top/bottom dead center position /2) is within
this tolerance, compensation will be applied.
Set the chopping axis clamp speed applied during
chopping.
Designate the order for automatically returning to the
restart position.
0: Do not return.
When 0 is designated for all axes, all of the axes
will return simultaneously.
II - 108
Details Setting range (unit)
0/1
0 to 32767 (µm)
M64 specifies a 0.5
µm unit.
0 to 32767 (µm)
M64 specifies a 0.5
µm unit.
0 to 10
(standard value: 8)
Micron:
0 to 10000 (µm)
Sub-micron:
0 to 10000
(0.1 µm)
Micron:
0 to 60000
(mm/min)
Sub-micron:
0 to 60000
(0.1 mm)/min
0 to 6